| WoodsBuggy.com http://www.woodsbuggy.com/phpBB3/ |
|
| EMPI header Quick Steel http://www.woodsbuggy.com/phpBB3/viewtopic.php?f=26&t=16821 |
Page 1 of 1 |
| Author: | 2800passat [ Sat Apr 05, 2014 10:01 am ] |
| Post subject: | EMPI header Quick Steel |
Anybody tried patching pin holes with this. Youtube says its good for 2400 degrees f. And works great on cracked manifolds. I have 3 pin holes in a row 5 inches out from the exhaust. Just trying not to buy more Chinese cheese. |
|
| Author: | klu408 [ Sat Apr 05, 2014 10:23 am ] |
| Post subject: | Re: EMPI header Quick Steel |
Well I don't see what you got to loose by trying it... could you braise it? Sent from my SCH-I605 using Tapatalk |
|
| Author: | kenny350 [ Sat Apr 05, 2014 2:18 pm ] |
| Post subject: | Re: EMPI header Quick Steel |
Used it to fix a few pin holes on my 350 warrior and it worked great. Just make sure you have it roughed up and cleaned good, also make sure it's fully cured before you put any heat to it or it will melt off like butter |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|