It is currently Thu Mar 28, 2024 4:38 pm

Board index » Tech and Fab » Parts Fabrication

All times are UTC - 5 hours [ DST ]




Post new topic Reply to topic  [ 3 posts ] 
Author Message
 Post subject: EMPI header Quick Steel
PostPosted: Sat Apr 05, 2014 10:01 am 
Offline
WB Contributor

Joined: Sat Feb 04, 2012 11:14 pm
Posts: 1418
Location: Birmingham, Alabama
Anybody tried patching pin holes with this. Youtube says its good for 2400 degrees f. And works great on cracked manifolds. I have 3 pin holes in a row 5 inches out from the exhaust. Just trying not to buy more Chinese cheese.


Top
 Profile  
 
PostPosted: Sat Apr 05, 2014 10:23 am 
Offline
User avatar

Joined: Tue Dec 03, 2013 10:37 pm
Posts: 182
Location: Boaz al.
Well I don't see what you got to loose by trying it... could you braise it?

Sent from my SCH-I605 using Tapatalk


Top
 Profile  
 
PostPosted: Sat Apr 05, 2014 2:18 pm 
Offline

Joined: Thu Nov 08, 2012 2:23 pm
Posts: 40
Location: Sarver Pa
Used it to fix a few pin holes on my 350 warrior and it worked great. Just make sure you have it roughed up and cleaned good, also make sure it's fully cured before you put any heat to it or it will melt off like butter

_________________
If the women don't find you handsome, they should at least find you handy -Red Green


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 3 posts ] 

Board index » Tech and Fab » Parts Fabrication

All times are UTC - 5 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 8 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group