I have an RCI aluminum fuel cell in my buggy. I'd like to add a remote fill for it. Anyone have any good ideas aside from buying one of the "fender fill" kits from Jegs or Summit? I think a good piece of hose would be fine but I need a plate at the top side to attach some sort of cap and neck for it.

_________________
"Obstacles are those frightful things you see when you take your eyes off your goal." -Henry Ford

Use a muffler clamp u bolt to go around your hose and drill a piece of flat plate or angle to attach it with. Chad

_________________
NOW GAS IT!!!!!

Do you have any junk cars around? A factory style fuel fill should have a tab on it and a lip at the hose end.
Good Luck
Kenric

I have seen a few like this one you can see half way down the page:
http://www.dansperformanceparts.com/buggy/fuel/buggyfuel1.htm

I would like to do something like this as well... But I have a round flue cell... So not sure.

Tank side
http://www.sandparts.com/servlet/the-24688/Fuel-Safe-Remote-Fill/Detail

Hope that helps?

Has anyone ever seen a neck extension for the poly tanks. I'm mounting mine lower and it'll be hard to get at it with the pump handle. I've never seen a hose adapter that will fit in the threaded fill on the poly tanks but I figure I'll ask anyway. Ya never know...

I should prolly just get a metal tank and be done with it.

_________________
has left the building...

I think you just unbolt the entire flange and bolt a new one on. It should have 10 or 12 bolts holding that entire assembly on.

_________________
"Obstacles are those frightful things you see when you take your eyes off your goal." -Henry Ford

I apologize I was speaking of the cheap crap poly tanks. After some more research I've decided to upgrade to stainless which I can weld and modify to my liking.

_________________
has left the building...