Anyone know where I can get a replacement rod? I need a 0-3...

I have my Dad's old set. About 25 years ago I bent the 1"-2" rod, we looked all over and couldn't find one back then. Luckily I was able to straighten the one I had. The rods come in 1" increments 0-1",1"-2", 2"-3" and so forth. Other then small shops that repair and calibrate precision tools it may be a tough find. If it were me I'd make one or modify one that's close before I'd give up.
Good luck.

_________________
Roads.... Where we are going, we don't need roads!

Have a new one made. Lots cheaper than buying a new Starret or Brown & Sharpe.jmo

_________________
Don't sweat the petty stuff, pet the sweaty stuff.

I did find one of these lastnight... Once it gets in it may do the trick...





This way I should be able to zero it out while its on teh deck height tool and measure from there..