hadnt thought of using either of those items.GENIUS!!!!
| WoodsBuggy.com http://www.woodsbuggy.com/phpBB3/ |
|
| Ball & Socket http://www.woodsbuggy.com/phpBB3/viewtopic.php?f=26&t=11845 |
Page 1 of 1 |
| Author: | kernal1984 [ Tue Jun 07, 2011 1:10 pm ] |
| Post subject: | Ball & Socket |
Where can i find a ball and socket setup like the one weddle uses in their linkage. I've looked online and cant seem to find exactly what im looking for. |
|
| Author: | davehix [ Tue Jun 07, 2011 2:09 pm ] |
| Post subject: | Re: Ball & Socket |
i used the ball out of one of these and used a 1/2 inch socket for the socket just had to hone it out a bit. http://cgi.ebay.com/Ball-Joint-Tie-Rod- ... 20b6459196 |
|
| Author: | Odyknuck [ Tue Jun 07, 2011 3:34 pm ] |
| Post subject: | Re: Ball & Socket |
How about something like this. They are avalable in 3/8" and 1/2": http://cgi.ebay.com/ebaymotors/NEIKO-3- ... veQ5fTools Heres a pair of them 1 - 3/8" and 1 - 1/2": http://cgi.ebay.com/ebaymotors/2Pc-3-8- ... 3368580e51 |
|
| Author: | kernal1984 [ Tue Jun 07, 2011 3:51 pm ] |
| Post subject: | Re: Ball & Socket |
hadnt thought of using either of those items.GENIUS!!!!
|
|
| Author: | MadMike [ Tue Jun 07, 2011 8:06 pm ] |
| Post subject: | Re: Ball & Socket |
Your welcome. |
|
| Author: | Odyknuck [ Wed Jun 08, 2011 9:37 am ] |
| Post subject: | Re: Ball & Socket |
Just a thought on the Impact style setup. You will need to drive the anti spin pin out so you have full articulation. Not sure if there is one or actually how they keep it fronm spinning however food for thought. I have not seen these to accertain. |
|
| Author: | wildwillie [ Thu Jun 09, 2011 12:38 am ] |
| Post subject: | Re: Ball & Socket |
i used a ball from a tierod end and a piece of 1 1/4 tube wit a brass bushing |
|
| Author: | kendel [ Mon Dec 03, 2012 2:12 pm ] |
| Post subject: | Re: Ball & Socket |
? i thought about this and you know what you dont need a "ball an socket" joint just a heim joint. weld the spud round rod to the transmision piece make it unersized so it slips in the ball of you heim joint the put the heim joint on the arm horizontal coming in from the back that way youve done the same thing! Keep the center of the ball about the same place as it would be with the ball an sockt joint and its done.
|
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|