Where can i find a ball and socket setup like the one weddle uses in their linkage.
I've looked online and cant seem to find exactly what im looking for.

_________________
IF IT AINT BROKE FIX IT TILL IT IS;)

i used the ball out of one of these and used a 1/2 inch socket for the socket just had to hone it out a bit.
http://cgi.ebay.com/Ball-Joint-Tie-Rod- ... 20b6459196

How about something like this. They are avalable in 3/8" and 1/2":

http://cgi.ebay.com/ebaymotors/NEIKO-3- ... veQ5fTools

Heres a pair of them 1 - 3/8" and 1 - 1/2":

http://cgi.ebay.com/ebaymotors/2Pc-3-8- ... 3368580e51

_________________
Water cooled Dry Sumped Subaru Powered Turbo Charged Fuel Injected 2500CC Tank. Oh Rah! He who dies with the most Toys not only wins, He also wears them out!

hadnt thought of using either of those items.GENIUS!!!!

_________________
IF IT AINT BROKE FIX IT TILL IT IS;)

Your welcome.

_________________
Of all the things I've lost, I miss my mind the most.
M
A
G
A

Just a thought on the Impact style setup. You will need to drive the anti spin pin out so you have full articulation. Not sure if there is one or actually how they keep it fronm spinning however food for thought. I have not seen these to accertain.

_________________
Water cooled Dry Sumped Subaru Powered Turbo Charged Fuel Injected 2500CC Tank. Oh Rah! He who dies with the most Toys not only wins, He also wears them out!

i used a ball from a tierod end and a piece of 1 1/4 tube wit a brass bushing

_________________
small minds condemn anything they fail to understand!

? i thought about this and you know what you dont need a "ball an socket" joint just a heim joint. weld the spud round rod to the transmision piece make it unersized so it slips in the ball of you heim joint the put the heim joint on the arm horizontal coming in from the back that way youve done the same thing! Keep the center of the ball about the same place as it would be with the ball an sockt joint and its done.