| WoodsBuggy.com http://www.woodsbuggy.com/phpBB3/ |
|
| Building spindles http://www.woodsbuggy.com/phpBB3/viewtopic.php?f=26&t=10349 |
Page 1 of 1 |
| Author: | Dave Winterburn [ Fri Sep 24, 2010 2:23 am ] |
| Post subject: | Building spindles |
If I were to make my own King Kong style spindles some time, I need some info. Who ever builds these must be using redilly available spindle spuds, but from what? Chev, Ford, Toyota something. Anyone know? Also, what are the crossover bearing and seal #'s. Thanks, Dave W. |
|
| Author: | Odyknuck [ Fri Sep 24, 2010 9:24 am ] |
| Post subject: | Re: Building spindles |
You can buy the stubs, wheel bearings & seals along with King pins and needle bearing etc. from most offroad suppliers like Kartec, McKenzies, Foddrill etc. |
|
| Author: | perrib [ Fri Sep 24, 2010 11:45 pm ] |
| Post subject: | Re: Building spindles |
Someone here made a set with full floating hubs from an Ford Explorer. |
|
| Author: | giveitagallon [ Sat Sep 25, 2010 2:15 pm ] |
| Post subject: | Re: Building spindles |
http://www.woodsbuggy.com/index.php?opt ... f=4&t=6750 |
|
| Author: | afterburnt [ Sun Sep 26, 2010 1:49 pm ] |
| Post subject: | Re: Building spindles |
I used Ford explorer spindles and for the hubs, i copied the ford explorer rotors out of aluminum just to save on weight. they have been working flawlessly so far. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|