I picked up a buggy at the end of last summer that was about 75% done. Some of you might remember the buggy it was nickschlemer's . It was a venture frame and I wanted to go with a stalker. So I tore it apart and sold off the parts I wanted to change and ordered up a stalker frame with a +6 roof. I now have most of my parts rounded up and am going to start building it.
Here is the 330 hp turbo charged suby engine!
I decided to try the RJES bellhousing adapter with the pull to release clutch and the subaru input shaft. This will allow me to run a turbo subaru clutch. The odd thing about the subaru turbo clutch is that it is a pull to release instead of a push to release clutch. By using their input shaft I also get to run the subaru clutch disk. The 6 rib tranny was built by Don's bus box and has all weddle gears and chromoly diff in it.
I'm running Eagle performance long travel beam with 2 1/4" longer trailing arms and 10" fox coil-overs. I have combo spindles with pro-am front brakes. On the rear i'm running a custom torsion with eagle performance coil-over conversion and 4x5 arms. The rear will have 18" fox coil-overs and gear one brakes.
The steering will be taken care of by a Saco rack with Howe power steering setup.
The wheels and tires are Keizer 15xx6 with goodyear 7.60 on the front and 15X10 with 33/12.50 boggers on the rear. Those will be mounted using Instigators adapters.
And I do hope to have to done for wellsville.
