| WoodsBuggy.com http://www.woodsbuggy.com/phpBB3/ |
|
| Bending tube http://www.woodsbuggy.com/phpBB3/viewtopic.php?f=23&t=12545 |
Page 1 of 1 |
| Author: | wyoming 1 [ Sat Nov 05, 2011 4:42 pm ] |
| Post subject: | Bending tube |
I was wondering if any one has ever used one of these www.affordablebender.com The price is right but I do not want to spend money on this and then have to buy a JD2 in three months. The only problem I see is it does not bend past a 90. Thanks for any input |
|
| Author: | davehix [ Sat Nov 05, 2011 4:47 pm ] |
| Post subject: | Re: Bending tube |
we used one of those to build a few buggys and it worked fine . just like you say it doesnt bend past 90 degree is the bad. |
|
| Author: | MickeyMouse [ Sat Nov 05, 2011 7:21 pm ] |
| Post subject: | Re: Bending tube |
The price is right.. It sure would be handy to be able to bend tubes in the garage. I am not sure about an entire frame but for a few random pieces, it would be great. |
|
| Author: | afterburnt [ Sat Nov 05, 2011 7:36 pm ] |
| Post subject: | Re: Bending tube |
that is the same tube bender that i copied, I used an enterpack cylinder with a air overhydrolic pump. I have built alot of cages from race car to full jeep roll cages and buggy frames. I have no problem with the machine not bending over 90 degrees. you will be able to use that for anything you need. |
|
| Author: | giveitagallon [ Mon Nov 07, 2011 6:01 pm ] |
| Post subject: | Re: Bending tube |
I have used afterburnts and it works great very simple to use also ! |
|
| Author: | Wanted_Fugitive [ Mon Nov 07, 2011 11:44 pm ] |
| Post subject: | Re: Bending tube |
I would say...BUY IT! |
|
| Author: | RaceBugg1098 [ Tue Nov 08, 2011 1:02 pm ] |
| Post subject: | Re: Bending tube |
not bad but you can just about buy a jd2 for that. |
|
| Author: | RaceBugg1098 [ Tue Nov 08, 2011 1:06 pm ] |
| Post subject: | Re: Bending tube |
http://www.ebay.com/itm/JD2-Model-3-Ben ... 415f184a85 http://www.ebay.com/itm/1-1-2-ROUND-TUB ... 45fcfea52e now you can bend 180* |
|
| Author: | nitro_mudder [ Tue Nov 08, 2011 1:19 pm ] |
| Post subject: | Re: Bending tube |
http://tubetek.net/products/product_details.php?p=7 Look at this site also, I think I had around $400 in it by the time I added air over hydrolic ram. Works great! |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|