| WoodsBuggy.com http://www.woodsbuggy.com/phpBB3/ |
|
| Chain Drive and Auto Trans Questions http://www.woodsbuggy.com/phpBB3/viewtopic.php?f=23&t=12265 |
Page 1 of 1 |
| Author: | gobig1971 [ Sat Sep 03, 2011 7:17 pm ] |
| Post subject: | Chain Drive and Auto Trans Questions |
This may be the wrong area to post this, and if so I apologize, but I have a couple questions on chain drives. I guess the main question I have is how wide are they on average, outside to outside rear tires? My other question is who can I talk to about possibly building one, or giving some advice on a build? Another question is, if I don't go chain drive, what would be a strong, reliable driveline that uses a fully automatic transmission? Has to be fully auto because I'll be driving with hand controls (I'm a quadriplegic), and has to have power steering. The buggy will be used for hills at Wellsville and my house, my hunting buggy or "treestand on wheels", as well as being a trail beater if it's not to wide. Thanks in advance for any help or suggestions. |
|
| Author: | kevin f [ Sat Sep 03, 2011 8:55 pm ] |
| Post subject: | Re: Chain Drive and Auto Trans Questions |
give kevin thomas a call. he builds a mean looking chaindrive chassis. 205-365-9778. |
|
| Author: | passat2800 [ Sat Sep 03, 2011 10:17 pm ] |
| Post subject: | Re: Chain Drive and Auto Trans Questions |
The Passat was absolutly Dangerous today with violent rpm, but you do what you gotta do.Watch our flicks this week. |
|
| Author: | Stevo [ Sun Sep 04, 2011 7:42 am ] |
| Post subject: | Re: Chain Drive and Auto Trans Questions |
Theres a guy in rochester pa that has a buggy forsale with a 3.1 gm full auto forsale. Ive seen him stop in the middle of the hills in wellsville then idle the rest of the way up. |
|
| Author: | MadMike [ Sun Sep 04, 2011 10:39 am ] |
| Post subject: | Re: Chain Drive and Auto Trans Questions |
Good advise Steve, buy something already done. Unless you have an unlimited supply of cash and in your case several friends that are above average in mechanical and fabrication, building from scratch wouldn't be advised. I MIGHT have some old hand control parts laying around here somewhere you might be able to use. |
|
| Author: | gobig1971 [ Sun Sep 04, 2011 4:58 pm ] |
| Post subject: | Re: Chain Drive and Auto Trans Questions |
Stevo, that sounds good to me. Is it listed on here or ? MadMike, thanks but I have already built my controls. Actually my 2nd set of my design. The 1st is going in my 29 Dodge hot rod. A full build/fab isn't that big of a deal to me but it would be nice to buy a completed, running buggy instead, and just make changes that are needed. I can understand doubts about a quad building a buggy, but being a mechanical engineer with a fully set up garage and machine shop helps. Again, thanks for the help and thoughts/suggestions. |
|
| Author: | MadMike [ Sun Sep 04, 2011 5:43 pm ] |
| Post subject: | Re: Chain Drive and Auto Trans Questions |
No doubts here, I advise all buggy newbee's to buy a finished car and go at it from there. Sounds to me you have the right attitude, motivation and equipment to do anything you want. You probably would give some able bodied folks I know a run for their money (pardon the pun). |
|
| Author: | Stevo [ Mon Sep 05, 2011 6:59 am ] |
| Post subject: | Re: Chain Drive and Auto Trans Questions |
I will get the info and pass it on to you. It runs good and very reliable. |
|
| Author: | gobig1971 [ Wed Sep 07, 2011 10:39 pm ] |
| Post subject: | Re: Chain Drive and Auto Trans Questions |
Stevo, any word or pics of that automatic buggy? |
|
| Author: | rockrockets1 [ Sat Sep 17, 2011 4:22 pm ] |
| Post subject: | Re: Chain Drive and Auto Trans Questions |
? kevin f wrote: give kevin thomas a call. he builds a mean looking chaindrive chassis. 205-365-9778.
|
|
| Author: | kevin f [ Sat Sep 17, 2011 5:22 pm ] |
| Post subject: | Re: Chain Drive and Auto Trans Questions |
rockrockets1 wrote: ? kevin f wrote: give kevin thomas a call. he builds a mean looking chaindrive chassis. 205-365-9778. Rock he lives down this way. He is one heck of a fabricator. He built his chassis from scratch and one other one so far. I must say they are bad ass. |
|
| Author: | Andrew_Ha [ Sat Sep 17, 2011 11:10 pm ] |
| Post subject: | Re: Chain Drive and Auto Trans Questions |
If u do want to build one IMO the person to talk to is curt. Someone on here should know how to get ahold of him between him and his dad they should be able to give u all the info u need rockrocket should be able to help u too |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|