| WoodsBuggy.com http://www.woodsbuggy.com/phpBB3/ |
|
| cam question http://www.woodsbuggy.com/phpBB3/viewtopic.php?f=2&t=9272 |
Page 1 of 1 |
| Author: | greenrail [ Wed Apr 14, 2010 9:57 pm ] |
| Post subject: | cam question |
I have a 2332 with a 125 ingle cam and was woundering if 1.25 rockers will help the bottom end power. the heads have had alot of port work to them and big valves |
|
| Author: | greenrail [ Thu Apr 15, 2010 8:45 pm ] |
| Post subject: | Re: cam question |
i was hoping to get some input on weather this is worth the money and time |
|
| Author: | hyde [ Thu Apr 15, 2010 9:21 pm ] |
| Post subject: | Re: cam question |
greenrail wrote: I have a 2332 with a 125 ingle cam and was woundering if 1.25 rockers will help the bottom end power. the heads have had alot of port work to them and big valves No it will not help bottom end cam is a little big. try small venturi & advance the cam 2 to 4 degrees & 6'' tall velocity stacks good luck. |
|
| Author: | aboone993 [ Thu Apr 15, 2010 9:28 pm ] |
| Post subject: | Re: cam question |
Are you sure its a 125 thats pretty big cam. I dont think you will ever like it in the woods . JMO |
|
| Author: | greenrail [ Thu Apr 15, 2010 11:13 pm ] |
| Post subject: | Re: cam question |
when i bought the motor i was told it had a 110 cam. I pulled the oil pump to check the cam and found out its a 125. I already bought the rockers . They should be here fri. When i seen what size cam I kinda thought that might be why it s very slugish below 2 grand. will i see any gain if i change the rockers at all or is it a waste of time? |
|
| Author: | chris38375 [ Fri Apr 16, 2010 8:28 am ] |
| Post subject: | Re: cam question |
its a waste of time if u want bottom end,would have to change cam |
|
| Author: | greenrail [ Fri Apr 16, 2010 5:39 pm ] |
| Post subject: | Re: cam question |
thanks for the help. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|