| WoodsBuggy.com http://www.woodsbuggy.com/phpBB3/ |
|
| pedals and metal tabs http://www.woodsbuggy.com/phpBB3/viewtopic.php?f=2&t=8714 |
Page 1 of 1 |
| Author: | hayshaker247 [ Sat Feb 13, 2010 12:05 am ] |
| Post subject: | pedals and metal tabs |
I just ordered m kirkey's and next on the list is pedals... where is the best place to get them? about the only place i know is dan's... i also want to get probably about 100 or so assorted tabs for seats, belts, engine cage,etc.. any suggestions would be great.. i'm looking for the hydraulic pedals gonna run front brakes too.. no factory replacement.. thinking of just getting a willwood slave cylinder.. the jeep has had one for 8 years so i trust they are good but pricey!! 
|
|
| Author: | bmoore [ Sat Feb 13, 2010 1:24 am ] |
| Post subject: | Re: pedals and metal tabs |
check out southern buggys on our sponsors page, and for the tabs if you have a race shop close by you can pick them up there. |
|
| Author: | Odyknuck [ Sat Feb 13, 2010 10:08 am ] |
| Post subject: | Re: pedals and metal tabs |
Just about any tab you want: aa-mfg.com |
|
| Author: | hyde [ Sat Feb 13, 2010 11:34 am ] |
| Post subject: | Re: pedals and metal tabs |
hayshaker247 wrote: I just ordered m kirkey's and next on the list is pedals... where is the best place to get them? about the only place i know is dan's... i also want to get probably about 100 or so assorted tabs for seats, belts, engine cage,etc.. any suggestions would be great.. i'm looking for the hydraulic pedals gonna run front brakes too.. no factory replacement.. thinking of just getting a willwood slave cylinder.. the jeep has had one for 8 years so i trust they are good but pricey!! are you in NKY Drews is about 30 miles N of NKY They had kirkey seats seting in the show room & have CNC pedales & fittings .Look at Drews on the web for a map . I go 275 w to winton road by bass pro & follow air port sines |
|
| Author: | hayshaker247 [ Sat Feb 13, 2010 8:17 pm ] |
| Post subject: | Re: pedals and metal tabs |
i didnt see anything on the aa-metal web site that was radiused for the 1.5 inch tubing... prolly check out drews for pedals. if i cant find tabs online i'll just go to my regular guy just a little pricy and far drive. |
|
| Author: | hyde [ Sat Feb 13, 2010 9:14 pm ] |
| Post subject: | Re: pedals and metal tabs |
hayshaker247 wrote: i didnt see anything on the aa-metal web site that was radiused for the 1.5 inch tubing... prolly check out drews for pedals. if i cant find tabs online i'll just go to my regular guy just a little pricy and far drive. THEY HAVE TABS |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|