| WoodsBuggy.com http://www.woodsbuggy.com/phpBB3/ |
|
| Throtal cable help http://www.woodsbuggy.com/phpBB3/viewtopic.php?f=2&t=5913 |
Page 1 of 1 |
| Author: | T.R.C [ Wed Feb 25, 2009 9:40 pm ] |
| Post subject: | Throtal cable help |
im trying to run cable through plastic white tubing iv seen used on other rails im e-nding up with to much slop how do you run that set up from petal to linkage at carbs thanks |
|
| Author: | piggnuts [ Wed Feb 25, 2009 9:57 pm ] |
| Post subject: | Re: Throtal cable help |
need a better description of "too much slop".....too long? |
|
| Author: | ncbuggy [ Wed Feb 25, 2009 10:06 pm ] |
| Post subject: | Re: Throtal cable help |
The cable housing needs to be zip-tied to something(brakeline,center bar). But don't pull it so tight that the cable rubs inside the housing. |
|
| Author: | T.R.C [ Wed Feb 25, 2009 10:24 pm ] |
| Post subject: | Re: Throtal cable help |
ok i ran it from rear torsion straight back and throw fan housing it seems much better.the cable was flexing to much makeing the gas pedal have slop in it.wouldnt acuat untill about 1inch of pressing it down the carb would just start to open thanks |
|
| Author: | piggnuts [ Wed Feb 25, 2009 10:37 pm ] |
| Post subject: | Re: Throtal cable help |
Ooooooh,now I get it |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|