Thanks, thats what I thought. I have a lot of ideas rambling around in my head(and some loose screws)
| WoodsBuggy.com http://www.woodsbuggy.com/phpBB3/ |
|
| 6-rib trans http://www.woodsbuggy.com/phpBB3/viewtopic.php?f=2&t=3061 |
Page 1 of 1 |
| Author: | FOX SHOX [ Fri Feb 15, 2008 6:20 pm ] |
| Post subject: | 6-rib trans |
Once you cut the end off of a 6-rib trans to install the bug engine can you ever install a bus engine back into it?? Thats why I'm asking for the 3-rib bell and input shaft in the parts section. I also have a high torque starter to fit the bug trans. Thanks Dave T |
|
| Author: | baja1965 [ Fri Feb 15, 2008 6:24 pm ] |
| Post subject: | |
i was told you could reinstall after cutting the shaft down. i have never tried it. DAREK |
|
| Author: | bevans37095 [ Fri Feb 15, 2008 6:43 pm ] |
| Post subject: | |
I'm assuming you mean cut the end off of the input shaft on the tranny. Yes you can put a type 4 motor back on the tranny but you'll have to replace the input shaft. It's better to swap the input shaft if you have one from a 3 rib rather than cutting it, but you have to do what it takes to get it going. It's an easy swap if you can find one. A lot of people do the swap so if you decide to put a bus or type 4 motor back on the tranny, it shouldn't be too hard to find a longer input shaft if yours gets cut. |
|
| Author: | FOX SHOX [ Fri Feb 15, 2008 7:11 pm ] |
| Post subject: | |
Thanks, thats what I thought. I have a lot of ideas rambling around in my head(and some loose screws)
|
|
| Author: | dunebuggy79 [ Fri Feb 15, 2008 9:24 pm ] |
| Post subject: | |
I might have one out of a 3 rib If you need it let me know and I`ll look for it. aaron |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|