WoodsBuggy.com
http://www.woodsbuggy.com/phpBB3/

MadMike trailing arms tough.
http://www.woodsbuggy.com/phpBB3/viewtopic.php?f=2&t=17701		 Page 1 of 1
Author:  hillaholic [ Sat Mar 14, 2015 1:07 am ]
Post subject:  MadMike trailing arms tough.
I'm running Mikes 3x3 trailing arms and have put them through hell. Think I've rolled it 4-5 times since I put them on.

This is one roll to show you what they've been through.
https://youtu.be/gYIXHrHCe2w

2 years later I decided to fix some damage after that roll. This will show you how tough his trailing arms are.

Beat on it for 2 years with the irs pivot like that. I did weld the bolt in just to get by.
Image

Knocked out the thread insert and crushed the stinger.
Image
Image

New Irs pivot I'll be installing.
Image

Another roll on his arms.
Image
Author:  MadMike [ Sat Mar 14, 2015 11:31 am ]
Post subject:  Re: MadMike trailing arms tough.
It's nice to know your work is appreciated, although I wish there was a less dramatic way to prove something is tough.
Thanks Brad.
Author:  hillaholic [ Tue Mar 17, 2015 9:29 pm ]
Post subject:  Re: MadMike trailing arms tough.
Fixed it finally.

Image
Image
Image
Image
Image
Author:  reno2165 [ Tue Mar 17, 2015 9:52 pm ]
Post subject:  Re: MadMike trailing arms tough.
I like the idea of running a bolt behind the pivot bolt to keep it from backing out 8)
Author:  gasman [ Wed Mar 18, 2015 8:27 am ]
Post subject:  Re: MadMike trailing arms tough.
Brad tested! And buggy approved! Lmao. One day soon I'll get my set of them out on the trails to beat on. Not only are they strong but with the extra bearing set up they are going to be better to run the bigger wider tire. Chad :mrgreen:
Author:  kydecoy [ Wed Mar 18, 2015 3:30 pm ]
Post subject:  Re: MadMike trailing arms tough.
Where did you get the new pivot point bracket?
Author:  hillaholic [ Wed Mar 18, 2015 4:49 pm ]
Post subject:  Re: MadMike trailing arms tough.
http://www.pacificcustoms.com/mm5/merch ... re_Code=PC
Author:  dunebuggynut [ Wed Mar 18, 2015 7:14 pm ]
Post subject:  Re: MadMike trailing arms tough.
The bolt on the backside beats grinding the tack weld off anytime I need to pull the pivot bolt. I'm gonna have to incorporate that in mine.
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/