Ok i was using a borrowed jd2 with every upgrade

However I hate to borrow any tool! Some of you will feel me on this.

Yes i know 300$ and buy one i just dont have it at this time.

Have a hf kinker (its was 40$)

I have an idea but wont say no to any one ideas on or help on it

http://m.youtube.com/watch?v=xYjH-9Y64to#

Problem is the hf bender ram is fixed so i havent had time to figure out the geometry with fixed ram

Any opinions on this?

Watch vid to get where im trying to go

Def a cheaper way to make dies. would like to see it work with a jd2 type wrap around bender.