Gonna paint my frame and I need to get that old paint off,Just one or two coats on there.We did one once before with a angle grinder with a brush on it and it was an all day ordeal.Just wondering what u guys do.Paint stripper,sand blast,or some other way?

_________________

Ive always sand blasted.

There is no easy way. Other than paying someone else to do it

easy off oven cleaner.

_________________

x2 Chad

_________________
NOW GAS IT!!!!!

I would not suggest aircraft stripper.It was the biggest pain in the a$$ ive ever dealt with.Spend a few hundred bucks and get it sandblasted or spay over top of it and ride.

Gasoline? When I bought mine the previous owner got stupid drunk flipped it and it caught fire and burnt to the ground. That took all the paint off. Seriously Scotch Brite pads that fit a sander/buffer and the small ones for your air die grinder work but take time. Even wih a renting large sand blaster and air compressor it takes 2-3 hours but you also get all the rust off. Last person I know got the compresor and blaster for around $100 per day. I have never tried paint stripper.

all i have to say is do NOT use the "ospho" knock off shit from home depot, go to the body shop store and get the real shit. I had to sandblast my entire frame and it still barely took that stuff off. For those that dont know, "ospho" is used to pull the impurities out of the steel before painting, uc an usually knock it off wtih scotchbrite. Sandblasting a buggy frame is miserable.

I had mine sandblasted as well as a handfull of parts for 200.00.

_________________
Turbocharged Ecotec,vanogon midshift,Berrien WoodsBuggy wagon.

I just use wire wheel on an angle grinder

_________________
i wana ride, i wana ride, i wana ride