WoodsBuggy.com http://www.woodsbuggy.com/phpBB3/ |
|
keeping terminals clean and dry? http://www.woodsbuggy.com/phpBB3/viewtopic.php?f=18&t=4552 |
Page 1 of 1 |
Author: | billykissell [ Thu Aug 28, 2008 3:17 pm ] |
Post subject: | keeping terminals clean and dry? |
does anyone have suggestions for cleaning and keeping wire terminals clean and dry? the only exposed wiring i have is on my coil, choke, idle cutoff, and starter jumper. non-ox only makes dirt stick. what about silicone? |
Author: | Odyknuck [ Thu Aug 28, 2008 3:20 pm ] |
Post subject: | Re: keeping terminals clean and dry? |
Liquid electrical tape. drys to a plyable state. |
Author: | MadMike [ Thu Aug 28, 2008 10:42 pm ] |
Post subject: | Re: keeping terminals clean and dry? |
Odyknuck wrote: Liquid electrical tape. drys to a plyable state. Agreed, works real good. If you can't find it try Dip-it. If your talking about RTV silicone I understand the chemicals in it attacks the metal in the solderless connector corroding it from the inside out. |
Author: | billykissell [ Fri Aug 29, 2008 8:30 am ] |
Post subject: | Re: keeping terminals clean and dry? |
does the liquid tape "glue" the terminals on, or can you remove them without too much trouble? |
Author: | billykissell [ Thu Sep 04, 2008 8:23 am ] |
Post subject: | Re: keeping terminals clean and dry? |
anyone? how tough is it to remove terminals once this stuff is on there? |
Author: | Odyknuck [ Fri Sep 05, 2008 9:18 am ] |
Post subject: | Re: keeping terminals clean and dry? |
No it does not glue them on. Its only a coating over the terminal. Sorry to get back to you so late. |
Author: | billykissell [ Fri Sep 05, 2008 2:13 pm ] |
Post subject: | Re: keeping terminals clean and dry? |
thanks, i-ll give it a try |
Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |