What's this fitting for?
| WoodsBuggy.com http://www.woodsbuggy.com/phpBB3/ |
|
| Radiator Fitting? http://www.woodsbuggy.com/phpBB3/viewtopic.php?f=17&t=3973 |
Page 1 of 1 |
| Author: | Bad Influence [ Sun Jun 01, 2008 8:11 pm ] |
| Post subject: | Radiator Fitting? |
What's this fitting for?
|
|
| Author: | Firebug [ Sun Jun 01, 2008 8:37 pm ] |
| Post subject: | Re: Radiator Fitting? |
Hard to tell but it may be for the automatic transmission cooler,,or something 
|
|
| Author: | Stevo [ Sun Jun 01, 2008 8:49 pm ] |
| Post subject: | Re: Radiator Fitting? |
Thats for transmission cooler. I have the same rad in the garage. There should be another one down lower. Is it leaking? |
|
| Author: | Bad Influence [ Sun Jun 01, 2008 9:10 pm ] |
| Post subject: | Re: Radiator Fitting? |
Steve wrote: Thats for transmission cooler. I have the same rad in the garage. There should be another one down lower. Is it leaking? I haven't filled the rad up yet. It's loose and just has a rubber cap on the end so I didn't know if I need to tighten it or plug it. |
|
| Author: | Stevo [ Sun Jun 01, 2008 9:33 pm ] |
| Post subject: | Re: Radiator Fitting? |
as long as the nuts are tight in the tank, you dont have to do anything. Somtimes the fitings come loose and leak water from the fiting. I would plug them incase you need a cooler and keep dirt out. |
|
| Author: | Bad Influence [ Sun Jun 01, 2008 9:36 pm ] |
| Post subject: | Re: Radiator Fitting? |
Thanks! |
|
| Author: | eggman [ Fri Nov 28, 2008 4:57 am ] |
| Post subject: | Re: Radiator Fitting? |
If that is the tranny cooler connection, why couldnt one run the engine oil thru it? Or would it get too warm running it through the radiator? |
|
| Author: | kybuggy1 [ Fri Nov 28, 2008 9:05 am ] |
| Post subject: | Re: Radiator Fitting? |
Passages in tranny coolers usually too small to run oil thru. They wont flow enough volume thru them. Found that out the hard way a few years ago.  .Larry |
|
| Author: | eggman [ Fri Nov 28, 2008 11:17 am ] |
| Post subject: | Re: Radiator Fitting? |
Ok, not enough flow. Makes sense. Thats why I asked. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|