| WoodsBuggy.com http://www.woodsbuggy.com/phpBB3/ |
|
| Alpha fab billet waterneck block http://www.woodsbuggy.com/phpBB3/viewtopic.php?f=17&t=17634 |
Page 1 of 1 |
| Author: | newbie26 [ Mon Feb 02, 2015 8:48 am ] |
| Post subject: | Alpha fab billet waterneck block |
Anyone use this block on the 2.2 ecotec and does the pipe from the water pump to the waterneck connect to it. Sent from my iPhone using Tapatalk |
|
| Author: | blackoutt [ Mon Feb 02, 2015 11:15 am ] |
| Post subject: | Re: Alpha fab billet waterneck block |
Yes the block works, as far as the cross over, thats a toss up. Mine didn't. Had to go get one from an 06 cobalt. |
|
| Author: | Alpha Fab [ Mon Feb 02, 2015 9:52 pm ] |
| Post subject: | Re: Alpha fab billet waterneck block |
blackoutt wrote: Yes the block works, as far as the cross over, thats a toss up. Mine didn't. Had to go get one from an 06 cobalt. The block will bolt up, however, like blackoutt said, you may need the longer 2.4 cross over pipe. It really depends on which year 2.2 you have. -AFI |
|
| Author: | newbie26 [ Mon Feb 02, 2015 11:53 pm ] |
| Post subject: | Re: Alpha fab billet waterneck block |
I have a 05 2.2 from a sunfire Sent from my iPhone using Tapatalk |
|
| Author: | blackoutt [ Tue Feb 03, 2015 2:52 pm ] |
| Post subject: | Re: Alpha fab billet waterneck block |
Easiest way to figure it out is, pull the crossover off and lay it on a table and see if both ends lay flat. The old crossover I had one end entered the old block on an angle. Both ends on the 2.4 crossover are the same. Sorry it's tricky to explain, needless to say the 2.4 has a little longer crossover and both sides enter the pump and block at the same angle. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|