not sure but this might help
| WoodsBuggy.com http://www.woodsbuggy.com/phpBB3/ |
|
| shift lever http://www.woodsbuggy.com/phpBB3/viewtopic.php?f=12&t=7802 |
Page 1 of 1 |
| Author: | odee [ Thu Oct 08, 2009 7:17 am ] |
| Post subject: | shift lever |
I had no reverse in this new buggy project I have gotten. Took the the front cover off to find the pin that the shift rod uses to move the interal lever had fell down. Looking at a blow up it appears to have had a clip on it. Does the small end go up or down? I see no grove for the clip. Could the piece that hold the clip in broken off? thanks |
|
| Author: | Maddog [ Thu Oct 08, 2009 9:49 am ] |
| Post subject: | Re: shift lever |
The front cover holds that pin in place, when it is installed. |
|
| Author: | odee [ Thu Oct 08, 2009 6:43 pm ] |
| Post subject: | Re: shift lever |
thanks, so when the cover is installed it rides on a portion of the cover to hold the pin in place with out a clip or such to support it. thanks again I'll go try it again. |
|
| Author: | chris38375 [ Thu Oct 08, 2009 7:38 pm ] |
| Post subject: | Re: shift lever |
thats it no clip,i think the small end goes up,it will only go one way |
|
| Author: | hillaholic [ Thu Oct 08, 2009 11:01 pm ] |
| Post subject: | Re: shift lever |
not sure but this might help
|
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|