WoodsBuggy.com http://www.woodsbuggy.com/phpBB3/ |
|
hydrualic slave cylinders http://www.woodsbuggy.com/phpBB3/viewtopic.php?f=12&t=5860 |
Page 1 of 1 |
Author: | odee [ Sat Feb 21, 2009 8:51 am ] |
Post subject: | hydrualic slave cylinders |
What slave and master cylinders are you guys uses on the buggys? Mine has a 3 rib trans if it matters on the application. thanks |
Author: | Strong [ Sat Feb 21, 2009 9:35 am ] |
Post subject: | Re: hydrualic slave cylinders |
CNC |
Author: | odee [ Sat Feb 21, 2009 3:12 pm ] |
Post subject: | Re: hydrualic slave cylinders |
thanks, I have heard that cnc makes a good product. Never used any yet. What bore size should a man go with on the slave and master cylinder? |
Author: | nickschlemer [ Sat Feb 21, 2009 10:12 pm ] |
Post subject: | Re: hydrualic slave cylinders |
I think the slave only comes in one size, and the bore on your master cylinder depends on your brakes? (disk or drum) |
Author: | Roy [ Sun Feb 22, 2009 9:42 am ] |
Post subject: | Re: hydrualic slave cylinders |
odee wrote: thanks, I have heard that cnc makes a good product. Never used any yet. What bore size should a man go with on the slave and master cylinder? Slave cylinder only comes in one size. The master cylinder for the clutch, most people run a 3/4" bore I believe. (that's what I use) You can use a 5/8 bore if using a stage 4 clutch. this will make it easier to push the petal. |
Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |