I'm trying to put my superdif in and need to know what to set the back lash for the ring gear,,Help please
| WoodsBuggy.com http://www.woodsbuggy.com/phpBB3/ |
|
| Back lash http://www.woodsbuggy.com/phpBB3/viewtopic.php?f=12&t=3940 |
Page 1 of 1 |
| Author: | Firebug [ Wed May 28, 2008 11:02 pm ] |
| Post subject: | Back lash |
I'm trying to put my superdif in and need to know what to set the back lash for the ring gear,,Help please
|
|
| Author: | Roy [ Fri May 30, 2008 2:03 pm ] |
| Post subject: | Re: Back lash |
Set it the same as it was before you took it apart. If you failed to measure it, set it around .005 and you will be ok. Don't forget to get your side bearing preload pretty tight when you install the new diff. Roy |
|
| Author: | Firebug [ Fri May 30, 2008 6:06 pm ] |
| Post subject: | Re: Back lash |
Is that where you tighten those big nuts 
|
|
| Author: | Roy [ Sat May 31, 2008 7:14 am ] |
| Post subject: | Re: Back lash |
Yes, those big screw collars. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|