Gives you an idea what it cost to gain a little wheelbase. A little more and you are in the cd range with several times the gains.
| WoodsBuggy.com http://www.woodsbuggy.com/phpBB3/ |
|
| Alternative to 930 stuff http://www.woodsbuggy.com/phpBB3/viewtopic.php?f=12&t=2783 |
Page 1 of 1 |
| Author: | Firebug [ Tue Jan 22, 2008 2:18 pm ] |
| Post subject: | Alternative to 930 stuff |
Here is an alternative to 930 stuff. http://cgi.ebay.com/ebaymotors/Rear-CV- ... enameZWDVW |
|
| Author: | chris38375 [ Tue Jan 22, 2008 4:03 pm ] |
| Post subject: | |
thats awesome |
|
| Author: | Eric DeBord [ Tue Jan 22, 2008 4:46 pm ] |
| Post subject: | |
I doubt that those are even close to being as strong as 930's. I used to run Datsun axles and the u-joints would not hold up (Even spicer ones). Since it is using 1-ton joints, it might be better. 50-60 lbs? Sounds heavy, but I really don't know what 930 setup weighs. I would also guess it takes more HP to turn these then cv joints. just my .02 |
|
| Author: | Kyle [ Tue Jan 22, 2008 4:59 pm ] |
| Post subject: | |
yea prolly wouldn't last spinning at speeds. but i do know 1-ton stuff is some TUFF stuff haha. i have watched many v8 rippp the 42's on rocks and not break heh. |
|
| Author: | Firebug [ Tue Jan 22, 2008 5:02 pm ] |
| Post subject: | |
Gives you an idea what it cost to gain a little wheelbase. A little more and you are in the cd range with several times the gains.
|
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|