Attachment:
Posted using the WoodsBuggy Mobile App
| WoodsBuggy.com http://www.woodsbuggy.com/phpBB3/ |
|
| Starter nut tricks ? http://www.woodsbuggy.com/phpBB3/viewtopic.php?f=12&t=16086 |
Page 1 of 1 |
| Author: | giveitagallon [ Mon Sep 30, 2013 9:17 pm ] |
| Post subject: | Starter nut tricks ? |
Wondering if anyone has any tricks to the top starter nut . It's so close to the bell housing you can only get a little 1/16 turn and the wrench head hits then ya have to dip the wrench and start all over again ..... Hate to try to do a trail if and have to deal with this , any suggestions ? |
|
| Author: | giveitagallon [ Mon Sep 30, 2013 9:19 pm ] |
| Post subject: | Re: Starter nut tricks ? |
Attachment: Posted using the WoodsBuggy Mobile App |
|
| Author: | davehix [ Mon Sep 30, 2013 9:33 pm ] |
| Post subject: | Re: Starter nut tricks ? |
ya use a factory bolt in it. 
|
|
| Author: | Stevo [ Mon Sep 30, 2013 9:47 pm ] |
| Post subject: | Re: Starter nut tricks ? |
davehix wrote: ya use a factory bolt in it. I second that, the factory bolt goes in from the starter side and the nut goes on the engine side. The bolt has a flat spot so it wont turn while tightening the nut. |
|
| Author: | GuyP [ Mon Sep 30, 2013 11:29 pm ] |
| Post subject: | Re: Starter nut tricks ? |
I used a piece of 10mm threaded rod with nuts and lockwashers on each end, no problem |
|
| Author: | diamonddav [ Tue Oct 01, 2013 12:50 am ] |
| Post subject: | Re: Starter nut tricks ? |
Guys i dont think hes talking about the starter bolt! Hes talking about the starter bolt:grin::o:mrgreen::-D Posted using the WoodsBuggy Mobile App |
|
| Author: | hillaholic [ Tue Oct 01, 2013 12:59 am ] |
| Post subject: | Re: Starter nut tricks ? |
|
|
| Author: | bige70chevy [ Tue Oct 01, 2013 1:38 am ] |
| Post subject: | Re: Starter nut tricks ? |
hillaholic wrote: thats what i have...easy to get to and turn the nut |
|
| Author: | Rick [ Tue Oct 01, 2013 8:11 am ] |
| Post subject: | Re: Starter nut tricks ? |
I have the bolt also |
|
| Author: | kevin f [ Tue Oct 01, 2013 10:57 pm ] |
| Post subject: | Re: Starter nut tricks ? |
I think he is talking about the bottom nut. I use a head nut off a big stud case and it gives clearance and makes it easier. |
|
| Author: | jesse [ Wed Oct 02, 2013 1:07 am ] |
| Post subject: | Re: Starter nut tricks ? |
If he talking the bottom nut in the pic then he needs that factory bolt brad posted to solve problem |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|