i came up with a easier way to make a better side shifter by using a common heim joint see below
this should work!
| WoodsBuggy.com http://www.woodsbuggy.com/phpBB3/ |
|
| another idea for side shifter http://www.woodsbuggy.com/phpBB3/viewtopic.php?f=12&t=14504 |
Page 1 of 1 |
| Author: | kendel [ Mon Dec 17, 2012 3:30 pm ] |
| Post subject: | another idea for side shifter |
i came up with a easier way to make a better side shifter by using a common heim joint see below this should work! |
|
| Author: | fortydegnorth [ Mon Dec 17, 2012 6:43 pm ] |
| Post subject: | Re: another idea for side shifter |
How does it shift? Looks like a good idea and a little easier than trying to find the ball and socket thing. I like it. Let us know how it does and someday I may copy it. What did you use for the long bushing? Is it a steering shaft bushing? |
|
| Author: | kendel [ Mon Dec 17, 2012 9:37 pm ] |
| Post subject: | Re: another idea for side shifter |
its a 5/8 shaft polished a little with flange bushing i made to fit a peice of pipe i found the shift pattern is tight with the Empi super shifter nick gave me the universals are latest rage china stuff but it aint steering! 
|
|
| Author: | davehix [ Tue Dec 18, 2012 3:46 am ] |
| Post subject: | Re: another idea for side shifter |
Does the pin on the lever slide in the heim joint? |
|
| Author: | kendel [ Thu Dec 20, 2012 6:02 pm ] |
| Post subject: | Re: another idea for side shifter |
yes. I used 7/16 heim and tured a "spud" from 1" round bar the 7/16 demesion is undersized to slip through the ball i milled 2 flat and cut a step in it to fit the trans peice an get most weld surface area. 
|
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|