^Bi-Hex
| WoodsBuggy.com http://www.woodsbuggy.com/phpBB3/ |
|
| CV Bolt http://www.woodsbuggy.com/phpBB3/viewtopic.php?f=12&t=11857 |
Page 1 of 1 |
| Author: | dieseltechy360 [ Fri Jun 10, 2011 8:35 pm ] |
| Post subject: | CV Bolt |
I have a stock car trans with original bolts in them. I cant find the right tool to remove them. Are they, Allen, Torx, or what ever else there may be. Also what size would be a big help!!!!!! Thanks again, Dieseltechy360 |
|
| Author: | jayrod [ Fri Jun 10, 2011 9:47 pm ] |
| Post subject: | Re: CV Bolt |
they are either allen or the stupid star bit. Pair of vise grips will help ya get the old junk ones out. then after they are out throw them across the garage and forget them lol THen go buy all new allen head bolts along with the allen socket for them. |
|
| Author: | buggiejunky [ Fri Jun 10, 2011 10:01 pm ] |
| Post subject: | Re: CV Bolt |
its a 8mm 12point bit autozone sells them in a 4 pack all vws use this type of bolt just different sizes |
|
| Author: | chris38375 [ Fri Jun 10, 2011 11:45 pm ] |
| Post subject: | Re: CV Bolt |
its either 6mm allen or 8 mm 12 point,,,take a small flat screw driver and clean it out and u can see what it is,,,,,by the way the 12 point is alot better,,the allen wrench sucks,,, |
|
| Author: | Stevo [ Sat Jun 11, 2011 6:26 am ] |
| Post subject: | Re: CV Bolt |
They are acually called "triple square" 8mm |
|
| Author: | PhillipM [ Sat Jun 11, 2011 9:39 am ] |
| Post subject: | Re: CV Bolt |
^Bi-Hex
|
|
| Author: | ridenrace6 [ Sat Jun 11, 2011 2:02 pm ] |
| Post subject: | Re: CV Bolt |
chris38375 wrote: by the way the 12 point is alot better,,the allen wrench sucks,,, why you say that i allways like my allen heads better, i kept busting those damn 12 point socket bits  
|
|
| Author: | chris38375 [ Sun Jun 12, 2011 10:07 am ] |
| Post subject: | Re: CV Bolt |
ridenrace6 wrote: chris38375 wrote: by the way the 12 point is alot better,,the allen wrench sucks,,, why you say that i allways like my allen heads better, i kept busting those damn 12 point socket bits all my allen heads got sloppy,probaly cause i use a small 18 volt dewalt impact,,,lol,,that will do it every time |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|