I have a single handle mounted between my seats. It moves a couple of inches each way. It too was angle handle and i ran it that way for a couple of years. This past winter i made it a straight handle and i like it much better.
| WoodsBuggy.com http://www.woodsbuggy.com/phpBB3/ |
|
| CNC cutting brake http://www.woodsbuggy.com/phpBB3/viewtopic.php?f=10&t=9957 |
Page 1 of 1 |
| Author: | MoblMec [ Sun Jul 25, 2010 7:50 pm ] |
| Post subject: | CNC cutting brake |
Hi Guys I have never had cutting brakes in a buggy so I have a few questions. I have a cnc single angled handle brake. Try to decide behind the seat handle coming foward or infront of the shifter and I will have to cut handel and weld it stright up. What I need to know is how much movement is there when you are applying the brakes compared to when they are empty and not hooked up. There is 7" throw one way empty and not hooked up. How much is there when hooked up??? I assume not near as much movement and tire locks up. Thanks Tim |
|
| Author: | tw9294 [ Sun Jul 25, 2010 10:22 pm ] |
| Post subject: | Re: CNC cutting brake |
I have a single handle mounted between my seats. It moves a couple of inches each way. It too was angle handle and i ran it that way for a couple of years. This past winter i made it a straight handle and i like it much better.
|
|
| Author: | perrib [ Mon Jul 26, 2010 8:24 pm ] |
| Post subject: | Re: CNC cutting brake |
Mine is close to the shifter. To the right and just forward of it. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|