| WoodsBuggy.com http://www.woodsbuggy.com/phpBB3/ |
|
| what master gyl. bore size http://www.woodsbuggy.com/phpBB3/viewtopic.php?f=10&t=9153 |
Page 1 of 1 |
| Author: | MoblMec [ Sun Mar 28, 2010 12:05 pm ] |
| Post subject: | what master gyl. bore size |
Hi guys I bought a dule cnc pedal setup with no master cyls. Now am looking for master cyls. I found a 1 inch bore size but my question is will that be too big for the nissan centra front calipers that I have on the back of my buggy??? Thanks MoblMec Tim |
|
| Author: | Firebug [ Sun Mar 28, 2010 12:34 pm ] |
| Post subject: | Re: what master gyl. bore size |
Very good question, some say the smaller the bore on the master the less pad needed. I would really like to know too. |
|
| Author: | nitro_mudder [ Sun Mar 28, 2010 5:35 pm ] |
| Post subject: | Re: what master gyl. bore size |
Larger bore master = shorter stroke but you need to push harder. Smaller Bore master = Longer stroke length but will create more pressure. Not sure how much you need for the sentras, but I need to get some for front calipers. |
|
| Author: | kybuggy1 [ Mon Mar 29, 2010 7:58 am ] |
| Post subject: | Re: what master gyl. bore size |
3/4" bore with the sentra calipers bled out good and you should have a good feelin foot pedal. |
|
| Author: | MoblMec [ Mon Mar 29, 2010 6:53 pm ] |
| Post subject: | Re: what master gyl. bore size |
OK I bought a cnc tall master cyl. with screw off top new off ebay for $20 so I thought I did good But the bore size is 1 inch think that will be ok for sentra calipers on the rear or will it be a too stiff pedal??? What do ya think????? Thanks MoblMec Tim Should be great. Bigger the bore on m/c , less pedal travel. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|