WoodsBuggy.com
http://www.woodsbuggy.com/phpBB3/

CNC Brake handle parts swap
http://www.woodsbuggy.com/phpBB3/viewtopic.php?f=10&t=8285		 Page 1 of 1
Author:  dunebuggynut [ Thu Dec 17, 2009 6:05 pm ]
Post subject:  CNC Brake handle parts swap
I got a hell of a deal on a new CNC staging brake for my front brakes. It has a blue knob & clevis.
Image
My buggy is gonna be red. Im not going to waste money to change these but if somebody has red ones on their blue buggy Ill swap you. I dont care if they are used.....as long as they are red.
Image
Image
Author:  MadMike [ Thu Dec 17, 2009 8:10 pm ]
Post subject:  Re: CNC Brake handle parts swap
You could sand blast them then powder coated with a translucient Red that is wild looking. I'm thinking on getting some of my Subie done that way.
Then again, might be cheaper to buy new ones.
Author:  dunebuggynut [ Fri Dec 18, 2009 4:14 pm ]
Post subject:  Re: CNC Brake handle parts swap
Its about 25 bucks to get new red ones. Im not that anal about them being blue. I just figured if somebody wants to swap I will.

That translucent coat looks killer over chrome but I think it would peel if scratched. It works well over the chrome-ish powdercoat though.
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/