WoodsBuggy.com
http://www.woodsbuggy.com/phpBB3/

930 stub question
http://www.woodsbuggy.com/phpBB3/viewtopic.php?f=10&t=8028		 Page 1 of 1
Author:  MoblMec [ Sat Nov 07, 2009 12:44 pm ]
Post subject:  930 stub question
Hi Guys
I am looking at a set of 930 micro stub set with brake calipers and roters, axel bearing and carriers that bolt in. I have 2x3 arms that were set up with weld in car bearing carriers. What would I have to do to make this work???
MoblMec
Author:  MoblMec [ Sat Nov 07, 2009 12:47 pm ]
Post subject:  Re: 930 stub question
O Yea I have buss axels and 6 rib tranny. Just not assembled yet!
Still gathering parts!!!
MoblMec
Author:  DUBclub [ Sat Nov 07, 2009 4:04 pm ]
Post subject:  Re: 930 stub question
well from what i know your buss axles would be well ... placed in the sold pile..and then you would have to buy 930 cvs and axles...that is what i had to do...dont forget the 930 drive flange too...maybe you know this but im new to my build

I have 3x3 with 930 type one stubs with gear one bolt on 4 piston calliper brakes to a 3 rib tranny...i was able to sell the cvs and axles to help me pay for the new parts... I am about to get my rear and front shocks welded so im kinda in your boat about storing up parts for my build!...

good luck hopefully you get your question answered...that is if my newbi 2 cents didnt help! :roll:
Author:  hyde [ Sat Nov 07, 2009 7:18 pm ]
Post subject:  Re: 930 stub question
MoblMec wrote:
Hi Guys
I am looking at a set of 930 micro stub set with brake calipers and roters, axel bearing and carriers that bolt in. I have 2x3 arms that were set up with weld in car bearing carriers. What would I have to do to make this work???
MoblMec

Drews off road had a pair of arms for micro stub & sales micro stub kits . talk to Brain Drew at 1-888-GO-DREWS Look at a-arm buggy at the brakes i run & racebugg.
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/