| WoodsBuggy.com http://www.woodsbuggy.com/phpBB3/ |
|
| CNC Pedals http://www.woodsbuggy.com/phpBB3/viewtopic.php?f=10&t=6480 |
Page 1 of 1 |
| Author: | pipedope [ Sun May 03, 2009 1:12 pm ] |
| Post subject: | CNC Pedals |
Quick ?? i went to rebuild my floor pedal and the piston poped out. which way does the rubber cup go? you have the plunger then a little black cup seal and im not sure which way it go cup up or cup down prob. over thinking it.lol |
|
| Author: | hillaholic [ Sun May 03, 2009 1:55 pm ] |
| Post subject: | Re: CNC Pedals |
You want the cup seal going into the bore so it pushes the fluid. If that’s what you’re asking. |
|
| Author: | pipedope [ Sun May 03, 2009 2:04 pm ] |
| Post subject: | Re: CNC Pedals |
thanks i went ahead and took the other 1 apart and look at it |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|