It is currently Sat Apr 27, 2024 6:48 am

View unanswered posts | View active topics


Board index » Tech and Fab » Brakes and Steering

All times are UTC - 5 hours [ DST ]



Post new topic Reply to topic  Page 1 of 1
  [ 3 posts ] 
  Print view Previous topic | Next topic 
Author Message
pipedope
 Post subject: CNC Pedals
PostPosted: Sun May 03, 2009 1:12 pm 
Offline
BOTM Winner
User avatar

Joined: Fri Dec 07, 2007 7:01 pm
Posts: 793
Location: LUCASVILLE OHIO
Quick ?? i went to rebuild my floor pedal and the piston poped out. which way does the rubber cup go? you have the plunger then a little black cup seal and im not sure which way it go cup up or cup down prob. over thinking it.lol

_________________
"It is easy to be brave from a safe distance."
Top
 Profile  
 
hillaholic
 Post subject: Re: CNC Pedals
PostPosted: Sun May 03, 2009 1:55 pm 
Offline
WoodsBuggy Addict
User avatar

Joined: Wed Feb 07, 2007 4:21 pm
Posts: 1560
Location: Elyria, Ohio
You want the cup seal going into the bore so it pushes the fluid. If that’s what you’re asking.
Top
 Profile  
 
pipedope
 Post subject: Re: CNC Pedals
PostPosted: Sun May 03, 2009 2:04 pm 
Offline
BOTM Winner
User avatar

Joined: Fri Dec 07, 2007 7:01 pm
Posts: 793
Location: LUCASVILLE OHIO
thanks i went ahead and took the other 1 apart and look at it

_________________
"It is easy to be brave from a safe distance."
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 1 of 1
  [ 3 posts ] 

Board index » Tech and Fab » Brakes and Steering

All times are UTC - 5 hours [ DST ]

Who is online

Users browsing this forum: No registered users and 41 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group