Piping brakes was a big learning curve for me. I had part metric fittings and part npt fittings. Several trips to autozone.
and alot of head scratchin. Good Luck, I'm sure you'll get it figured out.
| WoodsBuggy.com http://www.woodsbuggy.com/phpBB3/ |
|
| AN fitting Quetions http://www.woodsbuggy.com/phpBB3/viewtopic.php?f=10&t=4378 |
Page 1 of 1 |
| Author: | nickschlemer [ Sun Aug 03, 2008 12:06 am ] |
| Post subject: | AN fitting Quetions |
Hello everyone, Im trying to figure out the fittings i need for my brake lines. I bought all my hose and they all end with female -3 ends. So my question is what size hole is coming out of the CNC brake pedal master cylinder also the same with the turning brake and clutch. The fittings i need are double male sided with obviously -3 on one side and a american fitting on the other. Does anyone no these fittings.. Also i have to do the same thing on my front and rear calipers inlets My front breaks are Pro-am and my rear is Gear-one does anyone know what size these holes are?? CNC = ? to -3 Gear-One calipers= ? to -3 Pro-am caliper= ? to -3 Hopefully this makes sense and someone had the same problem and can just tell me what size holes are in all these products.. Thanks always Nick |
|
| Author: | Stevo [ Sun Aug 03, 2008 1:53 pm ] |
| Post subject: | Re: AN fitting Quetions |
The cnc stuff is 1/8th inch npt thread not sure on rest |
|
| Author: | Bad Influence [ Sun Aug 03, 2008 8:26 pm ] |
| Post subject: | Re: AN fitting Quetions |
Piping brakes was a big learning curve for me. I had part metric fittings and part npt fittings. Several trips to autozone. and alot of head scratchin. Good Luck, I'm sure you'll get it figured out.
|
|
| Author: | nickschlemer [ Sun Aug 03, 2008 10:09 pm ] |
| Post subject: | Re: AN fitting Quetions |
Hey Guys, Thanks forr the help looks like everything i have is 1/8 NPT and everything i bought is AN-3. But i got it all figured out. Im guessing the hole on my slave cylinder is 1/8NPT aswell.. |
|
| Author: | Odyknuck [ Mon Aug 04, 2008 12:47 pm ] |
| Post subject: | Re: AN fitting Quetions |
All of the aftermarket stuff is 1/8" NPT that I know of. |
|
| Author: | nickschlemer [ Mon Aug 04, 2008 8:57 pm ] |
| Post subject: | Re: AN fitting Quetions |
All my aftermarket stuff is. thanks for the help guys.. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|