| WoodsBuggy.com http://www.woodsbuggy.com/phpBB3/ |
|
| cutter brake http://www.woodsbuggy.com/phpBB3/viewtopic.php?f=10&t=3615 |
Page 1 of 1 |
| Author: | buddy7572 [ Mon Apr 14, 2008 8:20 pm ] |
| Post subject: | cutter brake |
i had to repalce rear brake line today. now i can't get my cutter to hold. the top one holds a little but the bottom one is not working at all. i went through 2 quarts of brake fluid trying to bleed them off . but i still have nothing. any help would be greatly appricated |
|
| Author: | buddy7572 [ Mon Apr 14, 2008 8:21 pm ] |
| Post subject: | cutter brake |
forgot it is a single handle cutter |
|
| Author: | fortydegnorth [ Mon Apr 14, 2008 10:56 pm ] |
| Post subject: | |
Did you bleed the cutting brake itself. You may need to take the caliper off and put a piece of wood or steel between the pads and then go through the bleeding process again except hold the caliper so its at the highest point of your brake system. If all else fails try a pressure bleeder that you either pump or connect an air hose to. |
|
| Author: | buddy7572 [ Wed Apr 16, 2008 8:06 pm ] |
| Post subject: | |
i tried all those things going to buy a rebuild kit tomorrow |
|
| Author: | dunebuggy79 [ Sat Apr 26, 2008 9:57 pm ] |
| Post subject: | |
When you bleed the brakes you need to make sure the bleeder your opening is the highest point on the caliper most of the time you need to unbolt it. aaron |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|