| WoodsBuggy.com http://www.woodsbuggy.com/phpBB3/ |
|
| mounting calibers http://www.woodsbuggy.com/phpBB3/viewtopic.php?f=10&t=17995 |
Page 1 of 1 |
| Author: | Gabuggy247 [ Thu Apr 14, 2016 2:56 pm ] |
| Post subject: | mounting calibers |
Got a set of nissian sentra calibers for the buggy and fixing to make mounts for them.How do I figure out exactly were the caliber should be. Should they be pushed pretty much against the out side pad? Thanks. |
|
| Author: | bigDsmith [ Fri Apr 15, 2016 12:04 am ] |
| Post subject: | Re: mounting calibers |
Place them on rotors as far toward the center as possible without passing the edge of rotor. Apply air to collapse caliper. This will reveal where to mount your bracket. Sent from my VS985 4G using Tapatalk |
|
| Author: | Gabuggy247 [ Fri Apr 15, 2016 8:21 am ] |
| Post subject: | Re: mounting calibers |
Thanks. Just pull bleeder out and shoot some air in there? Ill give that a shot. |
|
| Author: | bigDsmith [ Fri Apr 15, 2016 5:49 pm ] |
| Post subject: | Re: mounting calibers |
Yes, that will work. It's best if you can leave air hose on. So it doesn't move while worki,g on it. Sent from my VS985 4G using Tapatalk |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|