| WoodsBuggy.com http://www.woodsbuggy.com/phpBB3/ |
|
| Front brakes with king kong spindles http://www.woodsbuggy.com/phpBB3/viewtopic.php?f=10&t=16567 |
Page 1 of 1 |
| Author: | klu408 [ Fri Jan 17, 2014 9:35 pm ] |
| Post subject: | Front brakes with king kong spindles |
I have the combo spindles and want to put disk up front.. will a regular king pin setup work? And should I run a separate pedal or tired into the rears ahead of the turning brake? Posted using the WoodsBuggy Mobile App |
|
| Author: | MadMike [ Sat Jan 18, 2014 12:40 pm ] |
| Post subject: | Re: Front brakes with king kong spindles |
With the right bearings a stock link pin drum will fit a combo spindle. So if the rotors are designed to fit the stock link pin spindle it should fit. I always suggest to run a separate front brake system isolated from the rear. |
|
| Author: | klu408 [ Sat Jan 18, 2014 1:15 pm ] |
| Post subject: | Re: Front brakes with king kong spindles |
Yea i was looking those spindles have the threaded holes so may the king pin brake setup will work Posted using the WoodsBuggy Mobile App |
|
| Author: | RaceBugg1098 [ Tue Jan 21, 2014 1:14 pm ] |
| Post subject: | Re: Front brakes with king kong spindles |
are they combo spindles or king kong spindles? there is a big difference |
|
| Author: | klu408 [ Tue Jan 21, 2014 1:44 pm ] |
| Post subject: | Re: Front brakes with king kong spindles |
I'm not sure.. they were on buggy.. I think they are the race craft spindles judging by pics Posted using the WoodsBuggy Mobile App |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|