| WoodsBuggy.com http://www.woodsbuggy.com/phpBB3/ |
|
| DIY raised spindles http://www.woodsbuggy.com/phpBB3/viewtopic.php?f=10&t=15728 |
Page 1 of 1 |
| Author: | Aruba1 [ Tue Jul 23, 2013 9:30 pm ] |
| Post subject: | DIY raised spindles |
I am actually messing with raising the front of my buggy right now. I went to a buggy swap this past weekend and found a Ghia front disk brake kit with lowered spindles for $75. The good thing about lowered spindles is that you just need to use a thin disk grinder to cut through the welding beads. About 20 minutes later and some beating with a hammer and a chisel and they came apart. I am having issues removing the lower ball joint but as soon as I do I will have 1 side done. The calipers looks fine but at $80 for a loaded pair its not that bad. I will post some pics later during the week. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|