It is currently Sat Apr 27, 2024 10:39 am

View unanswered posts | View active topics


Board index » Tech and Fab » Brakes and Steering

All times are UTC - 5 hours [ DST ]



Post new topic Reply to topic  Page 1 of 1
  [ 3 posts ] 
  Print view Previous topic | Next topic 
Author Message
chadriley 5
 Post subject: weld on caliper mounts
PostPosted: Tue May 14, 2013 12:41 am 
Offline

Joined: Tue Nov 29, 2011 9:12 pm
Posts: 38
Location: hueytown,alabama
i have changed to a set of 3x3 boxed trailing arms and my caliper mounts will no longer bolt up to the axle flange.so i ordered some weld on caliper mounts.what do i do about shimming the bearing cap the thickness of the bolt on mount?should i just cut the mount down to just the flat part or what?
Top
 Profile  
 
Odyknuck
PostPosted: Tue May 14, 2013 8:02 am 
Offline
BOTM Winner
User avatar

Joined: Mon Apr 30, 2007 3:35 pm
Posts: 3097
Location: Rome Ohio
Yep, otherwise you will snap the lugs off the cap when you tighten the bolts.

_________________
Water cooled Dry Sumped Subaru Powered Turbo Charged Fuel Injected 2500CC Tank. Oh Rah! He who dies with the most Toys not only wins, He also wears them out!
Top
 Profile  
 
chadriley 5
PostPosted: Wed May 22, 2013 10:40 pm 
Offline

Joined: Tue Nov 29, 2011 9:12 pm
Posts: 38
Location: hueytown,alabama
anybody know of a good exploded view of the rear hub assembly.i ordered new seals and wanna make sure it all goes back together right
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 1 of 1
  [ 3 posts ] 

Board index » Tech and Fab » Brakes and Steering

All times are UTC - 5 hours [ DST ]

Who is online

Users browsing this forum: No registered users and 31 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group